Ok, so today I put in LED city lights and had to take out the stock intakes to get to the bulbs from the engine bay. I put everything back together, put the maf sensors clipped back in, when I went up the corner noticed my SES light was on.....? I did get a muffler delete just axleback on Saturday but I drove at least 125 miles since than and had at least 10 startups and no light at all. Any idea what this could be? I'll run it up to somewhere I can get it scanned tomorrow, but maybe someone could give me an idea, just a coincidence ? Here's a pic just for viewing . Thanks!

 

Curious about this as that I ordered some DD led city lights today but I plan on going through the wheel well to replace instead of removing the intakes. What kelvin and bulbs did you get?

 

I got cool white 6000k from Diode Dynamics. 92 Lumens. Looks great. Did my whole car interior and exterior with LED's from them.

 

Post the code when you get it scanned.

You could also unplug/plug in the MAFs making sure the electrical connector is fully pushed in.

 

Went to AutoZone I didn't get the exact code, but he the code read high tempature in the intake? Maybe it's just because I took out the intakes and put them back in, I retraced my steps and everything is buttoned up exactly as it was. He cleared it, didn't come back on yet, so hopefully it'll stay that way.

 

You may have just needed to drive a few miles, it should go away on its own once it gets breathing again.

 

I got the cool white also but the HP3's at 56 lumens. How close did the 92 lumens get to the HID's?