Not everyone Dynos after installing parts! Most say they feel gains by the butt dyno. Only dyno I did was with my headers before and after where there was a big improvement of 16whp but only 3wtq..
But like devilsg37s said every car is different some will have good gains while others will not

 

That looks really good IMO. Does the intake cover still go on or do you have to leave it off?

 

We fabricated the brackets off of the old intake and tapped the core support to make sure the brackets we solid. have had 0 issues. Its been raining a lot here in nor cal and i have the aftermarket grill so its wide open and still no issues.

 

interested in doing this or the stillen g3.( i have the k and n now)

for those who have done it did the silicone slide in where its sopost to with out any modification?

 

I went ahead and bought the z1, all their products have served me extremely well so far.

Anyone with pics of intake installed?

 

Post #24 in this thread...

 

Yes I saw it, looks sick just curious if others had some

 

That looks great. I really like this intake with those brackets installed. This and the Gen 3 Stillen are at the top of my list due to the MAF tube not necking down like they do on all of the other intakes. That has to disrupt air flow and the MAF readings.

 

 

Nice. Seriously considering these or the Takeda's. So no cutting or work to the air inlet holes correct Lorentzoe?

 

Yes you will have to cut for 2.5 inch pipe. I didn't I just shoved mine in the existing holes. Not to big of reduction.

 

Atta boy. Foreplay and finesse is overrated.

 

Hahaha! Instead of it being 2.5 circle it's like a smushed 2.5 circle. Butt dyno enjoys it. Takes all the noise out of the cabin the k and n typhoon had! Very pleased

 

I don't mind doing a little cutting to make it fit better. I'm hoping what little cutting may be required to get what makes me content i can do through the grille opening if i take it off instead of removing the whole front bumper.

I'm really leaning toward this intake though. Mostly because i like the matte grey they offer that looks like it matches the grey in my Graphite Shadow's engine bay pretty good from what i can tell...

 

I wonder if Z1 would be up for a group buy at their black Friday prices?? It looks pretty good IMO.