Just installed Stillen Gen3s and....
#16
Haha yeah, this one was totally my bad guys, sorry!
I actually had 4 bolts left over, 2 from the inlet tubes and 2 from the air box brackets if took out. (Stillen instructions don't say anything about it but I like to clean up the engine bay.... Plus weight reduction yo! Save 100th of a lb!!!!)
I actually had 4 bolts left over, 2 from the inlet tubes and 2 from the air box brackets if took out. (Stillen instructions don't say anything about it but I like to clean up the engine bay.... Plus weight reduction yo! Save 100th of a lb!!!!)
(2) bolts that attached the air box to the bracket
(2) bolts that attaches the bracket TO the frame (I just left my bracket on the car, don't want all these pieces around the house cause i'll forget later on)
(2) bolts from the OEM inlet cup thingy
Thread
Thread Starter
Forum
Replies
Last Post
SpeedBallDEVIL
Private Classifieds
3
08-12-2015 04:30 PM