Hi, After removing the interior and putting it back together I noticed a new issue, My Temp, RPM, Speed, and Fuel Gauges do not work anymore. I have replaced the IPDM, checked fuses, and Am about to swap the BCM once I get a key programmed to it but besides that Im not sure what else I should check apart from fuses and ground?

 

Okay so on a old post in this forum there is a discussion about this. It is stated that the harness for the radio and A/C have a identical connector that could be swapped and causes issues. There are actually two connectors that can be swapped not one. Both connectors have a yellow tape wrapped around them and both of those belong to the A/C amp. This will cause and/or Gauge cluster issues, A/C issues, Light issues.