When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Looking to run LED underglow lighting, but need to get the wiring out of the driver side floorboard (tapping a fuse), and into the outside world. Any advice on where I can run the wiring through that's factory?
Once you pull up the sill trim look for 2 (maybe 3) "black tape circles." These are holes that are already cut into the body of the car:
Above image is for passenger but the driver-side will be the same/ similar.
When I ran the OEM security lighting kit, I tapped into the illuminated door sills and passed the wiring through one of those cutouts.
Once you pull up the sill trim look for 2 (maybe 3) "black tape circles." These are holes that are already cut into the body of the car:
Above image is for passenger but the driver-side will be the same/ similar.
When I ran the OEM security lighting kit, I tapped into the illuminated door sills and passed the wiring through one of those cutouts.
I can confidently say I love you!! I have extra wiring so I can run this through passenger as well if needed! Now I just need to figure out the fuse tapping situation (already have two tapped, the cover struggles to fit back on with the taps sticking out of the slot 😭
