Red stitched arm rest lid/cover!
#1
Registered Member
Thread Starter
Red stitched arm rest lid/cover!
Found this skin on eBay and figured it would match with the red interior. Took off the lid and original skin and applied the new one with adhesive.
Leather seems legit, overall good quality. Highly recommended for those with red interior.. or if you want more red in your life.
What do y'all think?
Leather seems legit, overall good quality. Highly recommended for those with red interior.. or if you want more red in your life.
What do y'all think?
#7
Registered Member
Thread Starter
Original chrome piece is there but it’s hard to see in that pic. Arm rest is removed by taking off a plate with a flat head which reveals some screws. After that the arm rest is detached from the center console. Remove screws from the bottom of arm rest lid and top nest chrome piece. Now you can remove the existing cover skin. Installation was not too bad but but I found getting the new skin to fit around the chrome piece a pain to get near perfect. I used 3M spray adhesive. I should mention it does not pop up at quickly was it did with the original skin. The new one is thicker near the rear causing a resistance although, it’s getting better as I open and close.
The following users liked this post:
PNW_IPL (02-04-2018)
Trending Topics
#9
Would you guys know what is the part number for the chrome piece? I tried looking through discountinfiniti but couldn't find the part without the lid.
https://www.discountinfinitiparts.co...bC12Ni1nYXM%3D
https://www.discountinfinitiparts.co...bC12Ni1nYXM%3D
Original chrome piece is there but it’s hard to see in that pic. Arm rest is removed by taking off a plate with a flat head which reveals some screws. After that the arm rest is detached from the center console. Remove screws from the bottom of arm rest lid and top nest chrome piece. Now you can remove the existing cover skin. Installation was not too bad but but I found getting the new skin to fit around the chrome piece a pain to get near perfect. I used 3M spray adhesive. I should mention it does not pop up at quickly was it did with the original skin. The new one is thicker near the rear causing a resistance although, it’s getting better as I open and close.
Thread
Thread Starter
Forum
Replies
Last Post