Scratched inside door handles...WTF?
i would like to c some overlays from bat as wel...!! my gf scratched the shyt outta the passanger side panel wtf i almost killed her, but then i realized it was pretty common so w.e
Thread Starter
Registered User
Joined: Jun 2008
Posts: 538
Likes: 0
Dah, They replaced it No Charge! Why wait until the 09 washi comes out that is also made out of aluminum and is just as likely to scratch? And then pay $88 or more for the pleasure! Might as well just take it in the shorts!
Last edited by SFG37S; Aug 12, 2008 at 12:08 PM.
Because the current "aluminum" is neither aluminum or Wahsi. It's plastic. Very soft plastic. It's what I like to call a POC.
Ok ok
Ok, I can be wrong. I was just too sure it was plastic. It feels like plastic. I tapped on it and it just had that plastic sound. Maybe it's plastic coated. I promise I will be more certain of what I post in the future.
on the other hand I bet it's not aluminum. Maybe some metal.... but not aluminum. Are you sure it's in fact aluminum?
Whatever it is it is a POC.
Last edited by 04STi208G37; Aug 13, 2008 at 04:00 PM.
Thread Starter
Registered User
Joined: Jun 2008
Posts: 538
Likes: 0
Stick a magnet to it, That will tell ya! And if it where stainless it would not scratch as easily but it would weigh too much. In any case, I think we all agree this could be a little better done at the factory especially since the handle is so close to the seat. However, Am I gonna sell my G over it, Oh H E L L No! I just Love this car way too much!
Magnet
Stick a magnet to it, That will tell ya! And if it where stainless it would not scratch as easily but it would weigh too much. In any case, I think we all agree this could be a little better done at the factory especially since the handle is so close to the seat. However, Am I gonna sell my G over it, Oh H E L L No! I just Love this car way too much!
Last edited by 04STi208G37; Aug 13, 2008 at 09:34 PM.
