Hello ladies and gents

as the title says I replaced the galley gaskets over the weekend. However when I left today I had a very rough idle and after about 10-20 miles CEL popped and was thrown into limp mode. (Can’t rev above 2.5k rpm) replaces oil when servicing the galley gaskets.

here is the question I pose though around the timing valve solenoid I noticed some oil residue stained all over the front of the timing cover plate were the solenoid is. So if there is a leak coming from the o-ring on the solenoid and the solenoid is bad could that there by drop the oil pressure and cause the p0300 and rough idle ?


also! 2011 infinity g37x 140k
all stock

 

Damn nobody replied lol but bro did you ever figured it out? I’m having that issue rn

 

Possible bad solenoid caused oil leak, low pressure, rough idle, and error codes. Investigate and replace if needed.