Hello everyone couple months ago about a g37s that came with
A stillen supercharger, I want to put a turbosmart
Bov . I was told it's easy to install but Ima noon and
Dont know where it's located on the kit .
Stillen told me it's not a direct swap that I need custom
Work to put on . After asking a lot of people they
Told me there's no mods needed ....someone can help me out I'm in los Angeles .

 

Hey Cesar

If right in front of the radiator . : )

 

Quick question about this BOV how much did you adjust yours? by opening to soft or hard setting???

 

Correct me if im wrong, but looking at their website manual isnt this installed backwards? The boost side (inlet fitting) which is across from the top cap/ vacuum nipple should be attached to the longer hose connected to the inlet boot of the blower. The exhaust side (plumb back fitting) which is across the trumpet should be attached to the short hose connected to the charge pipe.
http://www.turbosmart.com.au/wp-cont...t_DualPort.pdf

 

Not sure whos pic I grabbed dont remember, Mine was long gone by the time I posted this. Just location , not how to hook it up

 

Sounds good So can you verify the instruction/picture I found on their website is that the correct way to install it? The reason I'm asking is I installed it backward the first time and my car keeps stalling out on gears and idle. Once I found this instruction and followed how to hook it up and adjust it run better. The car still need a final tune btw it only has base tune now.

 

Yes man, it is correct, If ever have questions you can test it yourself with the instructions. The boost pipe will always got the port where you can push the diaphragm in . The pic in link in your post is correct.

 

Thanks