Supercharger shipped today
Registered Member
iTrader: (2)
Joined: Jun 2008
Posts: 1,445
Likes: 2
From: ft hood texas, Middletown,CT
these cars from what i am getting are hard to tune because each cars' ecu reads the sensors a little different. there are so many veriations with the resistance in each wire and sensors. That would be my guess also
Registered Member
iTrader: (2)
Joined: Jun 2008
Posts: 1,445
Likes: 2
From: ft hood texas, Middletown,CT
all i can say a lot of my issues is from my installer. they used speaker wire instead of the wire that came with the kit to extend the sensors and didn't shrink wrap them correctly so it shorted out. I just found these things out. other than the sensors throwing off my tune the car was perfect. it is beyond perfect now thanks to stillen and uprev.
Thread Starter
Registered User
Joined: Jan 2010
Posts: 24
Likes: 0
From: tampa,FL
the belt slips at about 6800-7000 rpm stillen sending out a new tension bracket,then the car went into limp mode not letting me drive over 2500rpm threw a engine code p0441 but stillen is on it taking care of the problem not sure what it is yet but as soon as i know you will,it put down 406rwhp with stock exhaust,this is the short version of the story not all bad just little things,7at tuned on 93,i wasnt able to get it dynoed before the sc,sorry
Last edited by g2k; Jul 3, 2010 at 02:07 AM.
the belt slips at about 6800-7000 rpm stillen sending out a new tension bracket,then the car went into limp mode not letting me drive over 2500rpm threw a engine code p0441 but stillen is on it taking care of the problem not sure what it is yet but as soon as i know you will,it put down 406rwhp with stock exhaust,this is the short version of the story not all bad just little things,7at tuned on 93,i wasnt able to get it dynoed before the sc,sorry
all i can say a lot of my issues is from my installer. they used speaker wire instead of the wire that came with the kit to extend the sensors and didn't shrink wrap them correctly so it shorted out. I just found these things out. other than the sensors throwing off my tune the car was perfect. it is beyond perfect now thanks to stillen and uprev.
you're not the only one who's getting limp mode here. when my car first got done it was doing the same and throwing all kinds of codes, just wasn't driveable at all. then STILLEN was able to send us a new tune that solved most of the problems. i'm going back in today for a new tune again but this time it should fix all the quirks i'm experiencing.
