I don’t write a lot on here, but hopefully this will end up saving people some time and energy.
i finally got around to putting on my Tein coilovers today, still a work in progress, but every video I saw/ forum post I read, talked about how hard the front bolts were/are. Most talked about how you could get a torque wrench to the top bolt and end link nut, but not the bottom two bolts. All I did was unlock the steering wheel and turn the wheel to get the torque wrench to the bottom two bolts. Took me an hour to swap my front out.
So to whomever needs this, push the start button while not on the brake/clutch, then you can manually turn the rotors and get a torque wrench to all the bolts/nuts.