When adding camber arms to the rear, do you need to go with aftermarket toe bolts or can you use the stockers? I have ichiba camber arms, not installed, and I have been told that the toe bolts are not needed. Can anyone please shed some light on this?

 

Not needed.
What you should do during alignment is set the factory toe bolts to a neutral position first. That ensures even of the eccentric loosens, the alignment wont change.
SPL makes a square lockout washer to take place of the eccentric, that is the dogs bollocks.

 

I have the Stillen camber and toe arms. Along with the SPL lockout kit. No probs at all.

 

I had really hopped that I would get some more responses on this. I cant believe that there is only 2 people with experience with this. To the two people that did respond, Thank you.

 

I installed mine along with the rest of the camber kit. It only takes about 30 minutes to install and they're cheap too. So why not just to have the reassurance of getting the toe perfectly in spec?

 

Oh shoot, I misread your question, yes you do need the toe bolts, and to elongate the toe slot.
I meant you no longer need the camber bolts.