Well its actually more of a concern then a issue.. i recently purchased a double sided carbon fiber trunk with a molded lip after messing with it for 3 hours i finally got it installed today.... but i really DO NOT want to drill holes in it because it will be nearly impossible to get the hole in the middle of the trunk..

If i was to purchase one of those cameras that go onto the license plate screws from possibly pioneer would i be able to wire it to the OEM camera wiring so it works as oem avoiding putting holes in the bumper?? i know the wires have 4 colors: orange, Black, White (i think), and Red... The red and black are obvious but the other 2 i have no idea what they do....

So if i was to go that route is it possible to avoid drilling holes and wiring up the camera with a aftermarket camera...

i know alot of you will find this a bootlegged idea but i really dont want to mess up the trunk by drilling holes in it and possibly having a shop put the camera in crooked ...

All help greatly appreciated as this is time crucial because i absolutely DESPISE driving without a camera!!!

 

anyone?????????????????????????????????

 

??????????????????????????????????

 

Optimum placement is high. I think license plate mounted cameras have an extremely bad angle.

Also, I saw the camera assembly and it is pretty big so it might look awkward. However, I'm sure it would work and is completely possible. Just take the camera harness and extend it to below the car.