I did a search and couldn't find anything on this, but I know this topic has been covered.

How do you remove the map lights so you can swap out bulbs?

 

use a knife to pop the cover.

 

That's it? Just pop em off with a flathead?

 

There are TONS of threads on this and DIY sections. A plastic flathead screw driver would be best, wrap electrical tape (once around) a flat head and pry. There are 4 clips/attachment points close to the corners so just start in the middle of a side.

 

it's the easiest part to replace it. roll over some tapes on flat driver and put it in between gabs. easy to pop out.