ANYBODY KNOW A GOOD WAY TO REMOVE THE INFINITI AND FUJI BADGE OFF OF THE TRUNK WITHOUT HURTING THE PAINT FINISH? I WANTED TO MOVE THE G37S BADGE TO THE CENTER OF THE TRUNK. ANY ADVICE WOULD BE APPRECIATED, THANKS!

 

Check the DIY section. Should show you all the steps for this.

 

dental floss and blow dryer

 

hammer and chisel.

 

the caps lock button.

 

+1... the screaming hurt my ears.

 

The search button.

It's under the passenger seat toward the center console.

 

Goo Gone & Credit Card.

& hair dryer makes it easier.

 

Goo Gone, Dental Floss, Blow Dryer, Heat Resistant Fingers, and Patience...

 

Ooh, I want in on this!!

There's a button under the passenger seat that pops open a compartment in the center console that has a +2 Hammer of Thor and a +1 Chisel of Pygmalion inside—DON'T use them. And then... wait, what are we talking about again?

 

Well, if you really want to personalize your car, take the letters you’re going to remove and put some back saying: I IS NIFTI. It’s bad grammar, but at least meets your individuality requirement.

 

lighter fluid & a heat gun

 

thanks, Aliiin, madmikeg & Gamedog.

 

Don't forget the clean up afterwards.... have some polish AND or wax on standby afterwards... along with quickdetailer right after u clean up the residue.

If you have a claybar or will be detailing your car anyway, USE IT! Along with the quick detailer just after u've cleaned up the residue. Then go at it with polish and wax... oh and use micro fiber towels for all this.

 

use goo gone... that's what i did and it worked great, takes about 10 mins to do all this