William Gillins

jpowersjr2

iTrader: (1)

Did you ever figure this out?

ILM-NC G37S

iTrader: (3)

+1 for an update.
I am tired of the flickering LED's in my cluster (worse than the disco ball at 54) and am considering swapping. I do not have the time, or PATIENCE, for soldering those tiny LED's. Should be plug-and-play with exception to mileage, no?

(Melting dashboards, peeling trims, flickering LED's- more "quality" products from that POS company, Calsonic Kansei)

WillyButts

It works fine looks wayyyyy better and but what ever miles the new or used cluster has is what your car will reflect the doner car for me had 35k on it, my car had 75 so now my car is essentially had 35k on it, I swapped the entire interior and engine sooo it’s all good

ILM-NC G37S

iTrader: (3)

Thanks for the update. I am actually thinking of going a little bit further with the cluster swap... just have to check a few things. Mileage I'm not too concerned about.

WillyButts

Side note: It also doesn’t matter if it’s a manual or auto it’s yje same cluster and will read the auto gear selections or lack of in a manual

ILM-NC G37S

iTrader: (3)

Thanks! I'm covered there, my donor cluster only comes in automatic trim... getting it read the right signals, however...

Thx, again.