Mark this thread as Unsold
FS G37 Sedan RWD Cat-back - Invidia Q300.. kinda
#1
Registered Member
Thread Starter
G37 Sedan RWD Cat-back - Invidia Q300.. kinda
Category: Engine - Exhaust
Price: $245
Private or Vendor Listing: Private Listing
Part fits: 2010+ G37 Sedan, 2008-2009 G37 Sedan
Location (State/Prov): AR
Item Condition: Used
It's an Invidia Q300 full cat-back purchased in 2012 and it has about 43,000 miles on it. The car has been garage kept it's entire life and has seen very little salt/snow (if any) throughout it's life. That being said, it does show it's age. Here are the main points that you need to know:
1. The flanges where it bolts up to the cats have been modified to fit a 2.5" cat / test pipe. There were signs of an exhaust leak at this flange, not sure what the cause is because I've tried new gaskets and tightening it down myself. I have included a picture that shows the black carbon leaking out of the flange.
2. The flex pipes on the y-pipe will need replaced, or the entire y-pipe may be a better option. These are shown in pics as well.
3. You'll need new hardware such as gaskets, nuts and bolts. Actually you won't need new hardware for the X-pipe in the middle because I couldn't get those darn bolts off, so I decided to take it off as one piece along with the y-pipe. (I can provide what I have left over from the removal of the exhaust as well)
4. The Q300 mufflers have been replaced with custom twinloop mufflers to improve flow while keeping sound levels down. The Q300 mufflers are chambered mufflers so they were more restrictive than the replacements that I had put on.
5. I will not ship, local pickup only. I can meet you within a reasonable driving distance. I live in north Arkansas.
6. This exhaust fits G37 RWD Sedans. I don't know about AWD fitment.
As I said, the exhaust is perfectly functional as-is (if you have installation hardware) but there are some leaky points and it doesn't sound clean because of these leaks. Nevertheless, for this price, if you know a good shop, I would assume you can get this fixed for an all-in price around $500-600 total and have yourself a nice exhaust. Or just run it as a cheap carryover until you can afford a new, quality cat-back.
I can provide sound clips / videos as requested as well.
Last edited by backman_66; 09-26-2022 at 12:05 PM.
Trending Topics
#8
Registered Member
Thread Starter
I will ship it but it's going to be expensive and I'm not paying for it because my asking price for the exhaust itself is already the lowest I'll take, so I can't eat any shipping costs as well. I have a box and packing materials if you want to go this route though.
The following users liked this post:
Geee37 (07-27-2022)