Q50 Stock 17's
Thread Starter
Registered Member
iTrader: (13)
Joined: Dec 2009
Posts: 6,098
Likes: 395
From: Framingham Ma,
Q50 Stock 17's
Anyone know what spacers I should run with these? 25MM? I just want them to be flush with no drop. I'm not sure of the stock off sets. Thank you!
According to this site they are 17x7.5 +45
https://www.wheel-size.com/size/infiniti/q50/2016/
To get the same fit as a 9.5 +40 (which is nice & flush IMO) you'd need a 30mm spacer.
I think a 25mm would be pretty good, give you a little extra room but still a nice fit at the fender.
https://www.wheel-size.com/size/infiniti/q50/2016/
To get the same fit as a 9.5 +40 (which is nice & flush IMO) you'd need a 30mm spacer.
I think a 25mm would be pretty good, give you a little extra room but still a nice fit at the fender.
Thread Starter
Registered Member
iTrader: (13)
Joined: Dec 2009
Posts: 6,098
Likes: 395
From: Framingham Ma,
Question so when I go 18's I should look for a 18*9.5 or 18*9+30? There is a other set I am looking at is 18*8.5+ 35? Square set up with 245/45/18's. Thanx man!
Last edited by ANMVQ; Dec 4, 2017 at 07:22 AM.
To be honest I'm not sure the exact fit on the Q50 sedan, what offset will get you the flush fender fit may be off a few mm vs. a G37 Sedan.
The 9.5 +30 would seem to be pretty aggressive, my 9.5 +38 is very flush, so that 9+30 would be about 2mm outside the fender from mine, and the 9.5 another 6mm out from that. The 18x8.5 +35 would be the easiest fit for sure
The 9.5 +30 would seem to be pretty aggressive, my 9.5 +38 is very flush, so that 9+30 would be about 2mm outside the fender from mine, and the 9.5 another 6mm out from that. The 18x8.5 +35 would be the easiest fit for sure
