Opinion on these wheels
#1
Opinion on these wheels
Looking for a cheap set of 20's for my black x sedan that will fit well and are on the super cheap but still look good, came across these and for some reason they reminded me a tad bit of gtr wheels, and the size/offset is just right. Any opinions on them? Be brutally honest, besides the fact they are cheap, are they good looking or ugly fellas?
Giovanna Andros 20 x 8 5 10 Black L7 Rims Wheels for Infiniti G37 Coupe 35 | eBay
Giovanna Andros 20 x 8 5 10 Black L7 Rims Wheels for Infiniti G37 Coupe 35 | eBay
#3
Possibly I can't seem to find the weight of them anywhere, aren't all 20" cast wheels going to be heavier than stock wheels though? Even a brand like vossen or avant garde etc are heavy if they're cast 20's right?
#5
Just out of curiosity, let's say a set of 20's weighs in at 40 lbs heavier than a set of 19's, 10 lbs per corner, is this significantly different than adding 40 lbs to the trunk of the car in terms of performance loss, is it different because it's rotational mass vs dead weight? How much performance loss is there in actuality from it, will I drive the car and feel like it's slower by the butt Dyno because of a heavier set of 20's?
I legit don't know the answer to this stuff, I know a lot about performance, I have had several turbo cars and made 500 whp, but I've never put a set of heavy 20's on anything haha
#6
Registered Member
iTrader: (8)
Just out of curiosity, let's say a set of 20's weighs in at 40 lbs heavier than a set of 19's, 10 lbs per corner, is this significantly different than adding 40 lbs to the trunk of the car in terms of performance loss, is it different because it's rotational mass vs dead weight? How much performance loss is there in actuality from it, will I drive the car and feel like it's slower by the butt Dyno because of a heavier set of 20's?
I legit don't know the answer to this stuff, I know a lot about performance, I have had several turbo cars and made 500 whp, but I've never put a set of heavy 20's on anything haha
I legit don't know the answer to this stuff, I know a lot about performance, I have had several turbo cars and made 500 whp, but I've never put a set of heavy 20's on anything haha
#7
Movin On!
iTrader: (13)
If they both had the same concavity or at least similar they would look better, and the angled spokes don't really look that great IMO. The front wheels are almost flat and the rears a heavy concave, probably look a bit funky.
For just a bit more I'd look at the Niche wheel lineup
https://www.treaddepot.com/#!brandWheelList/nichecustom
For just a bit more I'd look at the Niche wheel lineup
https://www.treaddepot.com/#!brandWheelList/nichecustom
Thread
Thread Starter
Forum
Replies
Last Post
quakerroatmeal
Private Classifieds
0
11-06-2015 02:54 PM