Have an AWD sedan and want a nice square set of 19" Coupe Rims.

As I'll have to basically make the set from scratch.

Any feedback going with 19x8.5 on all four corners?

Would 19x9.0 be the preferred setup?



* found a cheap local set and the seller says they are curbed might not be totally straight.

Is there an "acceptable" tolerance for bent rims?

Is it usually visually obvious if they are not straight?

Thanks In advance for your input

 

Either 9 or 8.5 square will be fine and run 245/40/19s all around. As far as bent rims, I think I'd keep looking or maybe you can make a good pair from them and look for another two that match the width.
Here's a site if you need one or two
Infiniti G37 Wheels Rims OEM Alloy Steel Wheel Rim

 

Thanks for the info.

Will check out that site.