What did you do to your Sedan today?
#2357
Registered Member
Got my front and rear bumpers, lip, grills and rear roof wing painted and put on, and Also sanded and cleared my headlights.
Last edited by RazG; 03-19-2017 at 05:26 PM.
#2359
Registered Member
#2360
Registered Member
Changed the standard OEM filters over to K&N's air filters, changed the spark plugs, and went for a cruise with some friends; we ended up at this old Bugatti dealership in Wisconsin! Going to have to go there again for a better photoshoot and when my car is in "summer" mode.
#2361
Registered Member
Changed the standard OEM filters over to K&N's air filters, changed the spark plugs, and went for a cruise with some friends; we ended up at this old Bugatti dealership in Wisconsin! Going to have to go there again for a better photoshoot and when my car is in "summer" mode.
The following users liked this post:
MNfiniti (03-21-2017)
#2362
Registered Member
Installed my JDM tail lights today, complete set including the reverse lights! The reverse lights were a PITA to swap out because apparently they are glued to the trunk but I wanted to swap them out because the red lenses on the JDM tail lights are a shade darker than the USDM ones and my OCD would kill me to no end knowing that they are different
The following users liked this post:
VIVID (03-20-2017)
#2363
Premier Member
iTrader: (5)
I'm curious to know what you think of the Zmotering under-tray. How's the fitment? Does it seem solid? How's the placement of the "oil filter door" and will the oil changes be easier with the door? Etc... Inquiring minds want to know...
The following users liked this post:
Saltman (03-27-2017)
#2365
Registered Member
I think you installed them upside down
The following 3 users liked this post by the93owner:
The following users liked this post:
Calidoso (03-22-2017)
#2367
DIY Cheapskate/Mod
Ok, so the HPS couplers finally arrived. The clamps are now a perfect fit. Leave it to K&N to cheap out on thin couplers lol. Pardon the dirt, we just had a freak snowstorm, and salt got everywhere again... Plus shooting in the dark with a potato camera phone.
The following users liked this post:
hexotic (03-23-2017)
#2370
Registered Member
Well technically I didn't do anything, but I did order the last bit to install my coilovers. SPC Front Camber Arms. Ended up spending for more than I was expecting to just to get a drop.... but I'm very bad at settling and throwing lowering springs on high mileage shocks didn't sit well with me.