Brakes, Suspension, Wheels & Tires
Rollers and Rubbers (View All Posts)

tire pressure warning light...

Thread Tools
 
Search this Thread
 
Old Nov 17, 2007 | 12:38 AM
  #1  
UNV-IT46's Avatar
UNV-IT46
Thread Starter
Registered User
iTrader: (3)
 
Joined: Sep 2007
Posts: 3,985
Likes: 3
From: SoFlo
tire pressure warning light...

anyone know how to reset this damn thing? the book says it will reset once the pressure is set back but the problem is none of my tires are low. I went to a race track today and had to drive and park in a dirt lot. It was bumper as hell with tons of rocks. while leaving the light turned on i thought maybe a rock put a hole i check the tires all the same psi checked again when i got home still all the same so no air is coming out. so how the hell do i get the light off...
Reply
Old Nov 17, 2007 | 03:28 AM
  #2  
SilkeG's Avatar
SilkeG
Registered User
 
Joined: Mar 2007
Posts: 311
Likes: 0
Hope this is useful.

Resetting TPMS
From Page 2-13 of owner's manual:
The low tire pressure warning light does not automatically turn off when the tire pressure is adjusted. After the tire is inflated to the recommended pressure, the vehicle must be driven at speeds above 16 MPH (25 km/h) to activate the TPMS and turn off the low tire pressure warning light.
Interference of TPMS
From Page 5-5 of owner's manual:
Do not place metalized film or any metal parts (antenna, etc.) on the windows. This may cause poor reception of the signals from the tire pressure sensors, and the TPMS will not function properly.
From Page 5-6 of owner's manual:
Some devices and transmitters may temporarily interfere with the operation of the TPMS and cause the low tire pressure warning light to
illuminate. Some examples are:
± Facilities or electric devices using similar radio frequencies are near the vehicle.
± If a transmitter set to similar frequencies is being used in or near the vehicle.
± If a computer (or similar equipment) or a DC/AC converter is being used in or near the vehicle.
TPMS Malfunction
From Page 2-13 of owner's manual:
If the TPMS is not functioning properly, the low tire pressure warning light will flash for approximately 1 minute when the ignition switch is pushed ON. The light will remain on after the 1 minute. Have the system checked by an INFINITI dealer.
Reply
Old Nov 17, 2007 | 09:04 AM
  #3  
UNV-IT46's Avatar
UNV-IT46
Thread Starter
Registered User
iTrader: (3)
 
Joined: Sep 2007
Posts: 3,985
Likes: 3
From: SoFlo
ya i read all those already. it is not blinking at all. just coming on and staying on. but the psi is the same in all 4 tires....
Reply
Old Nov 17, 2007 | 01:27 PM
  #4  
shumby's Avatar
shumby
Registered User
iTrader: (3)
 
Joined: Sep 2007
Posts: 2,668
Likes: 5
From: With your mom
Wheni Changed my tires I had to go bact to the dealer for them to reset. It was free and they said they had to do it I could not do it myself. I believed them because they said they will do it for free every time I change my wheels.
Reply
Old Nov 18, 2007 | 01:14 AM
  #5  
JLai's Avatar
JLai
Registered User
 
Joined: Oct 2007
Posts: 1,381
Likes: 2
From: Ponte Vedra, FL
Originally Posted by SilkeG
Interference of TPMS
From Page 5-5 of owner's manual:
Do not place metalized film or any metal parts (antenna, etc.) on the windows. This may cause poor reception of the signals from the tire pressure sensors, and the TPMS will not function properly.
Now I'm happy I spent the extra $45 for the 3M non-metalized this morning. I was mostly concerned about Nav and XM...didn't even think about TPMS.
Reply
Old Dec 5, 2007 | 08:10 PM
  #6  
cyberjock4hire's Avatar
cyberjock4hire
Registered User
 
Joined: Sep 2007
Posts: 34
Likes: 0
When the temp dropped below freezing I noticed the TPS warning light go off, they were about 30psi. Inflated the tires to 35psi, drove for a bit and the warning light went off. About a week or so went by and I got my winter tire set from tire rack and I ordered them with no TPS modules because I did not feel like adding $400.00 to the cost. So the winter tires are on for about a week or so now and I have yet to see the tps light go on. Strange, but not complaining.
Reply
Old Dec 5, 2007 | 08:13 PM
  #7  
User 111021's Avatar
User 111021
Registered Member
iTrader: (2)
 
Joined: Mar 2006
Posts: 732
Likes: 5
Originally Posted by JLai
Now I'm happy I spent the extra $45 for the 3M non-metalized this morning. I was mostly concerned about Nav and XM...didn't even think about TPMS.

I have metallic tints, how does a Tire Monitor, get affected by the rear window, odd..
Reply
Old Dec 5, 2007 | 09:14 PM
  #8  
rrrevin's Avatar
rrrevin
Registered User
 
Joined: Sep 2007
Posts: 376
Likes: 0
From: Calgary, Ab
Originally Posted by UNV-IT46
ya i read all those already. it is not blinking at all. just coming on and staying on. but the psi is the same in all 4 tires....
1st question .. did you get new tires put on with TPMS devices installed? If not.. you've found your problem.

If you did, then you have to go to the dealer to get the new TPMS devices recognized by the system. The system is looking for the old devices.
Reply
Old Dec 5, 2007 | 10:14 PM
  #9  
JLai's Avatar
JLai
Registered User
 
Joined: Oct 2007
Posts: 1,381
Likes: 2
From: Ponte Vedra, FL
Originally Posted by Raheel
I have metallic tints, how does a Tire Monitor, get affected by the rear window, odd..
I'd rather just follow the manual...that way it eliminates that as a source if anything goes wrong. Having just spent $45K on a car, an extra $50 to get better tint seems like a drop in the bucket. Besides, I compared it side by side and the color stable looks much better than the metallic. So it was worth it to me.
Reply
Old Dec 6, 2007 | 05:29 AM
  #10  
UNV-IT46's Avatar
UNV-IT46
Thread Starter
Registered User
iTrader: (3)
 
Joined: Sep 2007
Posts: 3,985
Likes: 3
From: SoFlo
Originally Posted by rrrevin
1st question .. did you get new tires put on with TPMS devices installed? If not.. you've found your problem.

If you did, then you have to go to the dealer to get the new TPMS devices recognized by the system. The system is looking for the old devices.
1st question did you read my first post? if not... you've found your problem.....
Reply
Old Dec 6, 2007 | 09:17 AM
  #11  
RedHerring's Avatar
RedHerring
Registered User
iTrader: (1)
 
Joined: Aug 2007
Posts: 362
Likes: 2
From: Chattanooga, TN
No, his problem is that he is trying to help you, and leave a little useful information laying around for the rest of us.

Personally, I am thankful because I didn't know that the TPMS sensors were serialized. Thanks!
Reply
Old Dec 6, 2007 | 12:31 PM
  #12  
joeposter's Avatar
joeposter
Registered Member
 
Joined: Sep 2007
Posts: 270
Likes: 2
Originally Posted by UNV-IT46
but the psi is the same in all 4 tires....
At 35 PSI?
Reply
Old Dec 6, 2007 | 01:48 PM
  #13  
User 111021's Avatar
User 111021
Registered Member
iTrader: (2)
 
Joined: Mar 2006
Posts: 732
Likes: 5
Originally Posted by JLai
I'd rather just follow the manual...that way it eliminates that as a source if anything goes wrong. Having just spent $45K on a car, an extra $50 to get better tint seems like a drop in the bucket. Besides, I compared it side by side and the color stable looks much better than the metallic. So it was worth it to me.
$50 extra..? My Llumar Metallic Was $50 More than Ceramic....

Metallic costs more than Ceramic, Most people like me get Metallic cuz they want the shiny tint to it, its actually more expensive...
Reply
Old Dec 6, 2007 | 01:55 PM
  #14  
UNV-IT46's Avatar
UNV-IT46
Thread Starter
Registered User
iTrader: (3)
 
Joined: Sep 2007
Posts: 3,985
Likes: 3
From: SoFlo
Originally Posted by RedHerring
No, his problem is that he is trying to help you, and leave a little useful information laying around for the rest of us.

Personally, I am thankful because I didn't know that the TPMS sensors were serialized. Thanks!
it was a joke my friend calm down.
Reply
Old Dec 6, 2007 | 01:56 PM
  #15  
UNV-IT46's Avatar
UNV-IT46
Thread Starter
Registered User
iTrader: (3)
 
Joined: Sep 2007
Posts: 3,985
Likes: 3
From: SoFlo
Originally Posted by joeposter
At 35 PSI?
yep. i raised it back up to 35 and still nothing. I am starting to think maybe driving over the rocks maybe damaged one of the sensors....
Reply



All times are GMT -4. The time now is 01:59 AM.