Category: Engine - Complete Motors
Price: $1000
Private or Vendor Listing: Private Listing
Part fits: 2008-2009 G37 Coupe
Location (State/Prov): CA
Item Condition: Used

So the shop I sold my g/f's swap to just spun a bearing in the 20k VQ37VHR swap I had sold them.

Now they are trying to make some money back by selling the heads. And stock intake manifold. Or maybe parting out the engine?

They are testing the waters to see if there is any interest in this stuff. If there is, they are going to part out the motor. If not, they are going to put in a new crank and after market rods.

The motor was running a pair of gt28's at 10psi when it spun the bearing.

Obviously make me an offer and I will relay it to them.

If there is enough interest the whole engine will be parted out block and oilpan are fine, the rod didnt snap lol. Only one of the rods spun and one rod and the crank is bad.

PM me.

 

You need to set a price to keep this thread open

 

okay done.

 

wow no interest at all?

 

Maybe if the heads were ported or had bigger valves but stock I don't think anyones going to be interested in....

 

These could be used as cores?

They are going on eBay then I guess..

 

bump????

 

too much. just to let you know, there are a lot of places selling the entire engine for 1,200-1,400. So 1k just for the heads are a bit much. my opinion would to lower the price.

 

I have no idea what you just said

 

I sold the swap (engine tranny) to a sand rail shop here locally. The swap is out of my g/f's totaled car.

They ran 2 gt28's on it, until it spun a bearing.

Now they just have a really expensive paper weight lol