Mark this thread as Unsold
FS Feeler: Stillen Intake
Im still here, just contemplating offers (mainly low *****..just ignoring these). I could understand low ***** on a well used system, but this system is 7.5 days old.
And to answer most questions, yes I do have the shield, the four worm clamps, and four t-bolt clamps..believe there were two mini worm clamps, and the bracket to bolt the two filters inline. I also bought some extra hosing because the intake tubes are too far to reuse the stock pcv tubing. Might have the instructions which basically tell you to take your front bumper off, use a hole saw of some sort to open the stock intake shroud to allow the pipe to fit through. Then put everything back together again.
And to answer most questions, yes I do have the shield, the four worm clamps, and four t-bolt clamps..believe there were two mini worm clamps, and the bracket to bolt the two filters inline. I also bought some extra hosing because the intake tubes are too far to reuse the stock pcv tubing. Might have the instructions which basically tell you to take your front bumper off, use a hole saw of some sort to open the stock intake shroud to allow the pipe to fit through. Then put everything back together again.
Checking in to see if you recieved my PM reply. Ive confirmed the offer price. Lets get this deal wrapped up
.Thanks,
Mitch
Thread
Thread Starter
Forum
Replies
Last Post
Tuckermaclain
G37 Sedan
59
Oct 5, 2015 11:41 PM
