When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I have a question, are the original ***** suppose to just pop out? I pulled at it with both hands and it won't move... Don't want to snap it.
They'll come out, just keep a firm grip as you pull straight out. Someone mentioned using double sided tape to get a better grip.
When installing the replacement ***** you might want to add a very small amount of vaseline (or similar) to the tip of the studs and then push the new ***** straight in.
Also, the replacement ***** are two different length sizes (like the OEM)
I have a question, are the original ***** suppose to just pop out? I pulled at it with both hands and it won't move... Don't want to snap it.
Yes like Gio said the original ***** will just pull out no problem. They are not clipped clamped or glued in any way. You can also try using pliers to get a better grip, just make sure you don't squeeze too hard to damage the OEM *****, and also wrap the pliers with tape or towel to prevent them from cutting ur OEM *****.
They'll come out, just keep a firm grip as you pull straight out. Someone mentioned using double sided tape to get a better grip.
When installing the replacement ***** you might want to add a very small amount of vaseline (or similar) to the tip of the studs and then push the new ***** straight in.
Also, the replacement ***** are two different length sizes (like the OEM)
g/l
Yeah, that was me Gio. The double sided tape or regular scotch tape (one wrap, twist and wrap again with sticky side out) will give you grip so you can pull them out. Will work much easier. GL.
Thanks guys, i just gave up and pulled them out with pliers, lol. I wrapped the pliers with a towel yet it still flattened and scraped the OEM *****. Looking good and won't be going back so all good .
.