O2 sensor question
Thread Starter
Registered User
Joined: Aug 2009
Posts: 269
Likes: 5
From: Maryville, TN
O2 sensor question
i have a CEL with my HFC (i have reset my ecu several times using the gas pedal method), so i was going to do the non-fouler extender method maybe this weekend.
Are the O2 sensors hard to get off? A shop did the install for me, so should they theoretically be pretty easy to get off now? Its been a few months
Any special tools or just the appropriate sized wrench?
Do people still stuff brillo pads in there as well?
Are the O2 sensors hard to get off? A shop did the install for me, so should they theoretically be pretty easy to get off now? Its been a few months
Any special tools or just the appropriate sized wrench?
Do people still stuff brillo pads in there as well?
Registered User
Joined: Feb 2014
Posts: 291
Likes: 26
From: Key West, FL
Thread Starter
Registered User
Joined: Aug 2009
Posts: 269
Likes: 5
From: Maryville, TN
i did search. thats why i created this thread
did you even read my post? i can link you to quite a few more DIYs on my350z.com showing how to do the double anti fouler method, but that again does not address my post.
take a deep breath and try again IYAM
did you even read my post? i can link you to quite a few more DIYs on my350z.com showing how to do the double anti fouler method, but that again does not address my post.
take a deep breath and try again IYAM
Thread
Thread Starter
Forum
Replies
Last Post
04G35NYC
Private Classifieds
13
Dec 24, 2015 01:00 AM
