first mxp installed!!!
Hey Danny, thanks for sharing your experience. I'm debating between HKS and MXP to replace my Tanabe. The Tanabe drones too much for my taste. Like you said, between 40-50, I notice quite a bit of drone.
With the possible fitment issue, I might be leaning towards HKS but from the videos I kinda like the MXP tone more. Then again, videos doesn't do justice and unfortunately there aren't very much active G37s in forum around my area with these exhausts for me to hear in person. Decisions...Decisions...
With the possible fitment issue, I might be leaning towards HKS but from the videos I kinda like the MXP tone more. Then again, videos doesn't do justice and unfortunately there aren't very much active G37s in forum around my area with these exhausts for me to hear in person. Decisions...Decisions...
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
Guess I'll wait and see what comes out of the MXP fix on Richie's exhaust.
So Richierich, is it safe to say that your tip sitting lower/unever is a DIRECT result of the AT diff issue? Can Mackin confirm that the current build sits and will fit perfectly on an MT model? Can you ask for me please, if you don't mind?
I do wish you best of luck with them remedying your situation.
I do wish you best of luck with them remedying your situation.
Joined: Oct 2007
Posts: 2,335
Likes: 1
From: Metro Detroit, MI [Sterling Hts.]
Mackin should have a 6MT G37 come in to swap the exhaust onto that and see if fitment checks out fine so that we know whether it's AT driveshaft/diff specific issue.
Joined: Oct 2007
Posts: 2,335
Likes: 1
From: Metro Detroit, MI [Sterling Hts.]
Joined: Oct 2007
Posts: 2,335
Likes: 1
From: Metro Detroit, MI [Sterling Hts.]
Joined: Oct 2007
Posts: 2,335
Likes: 1
From: Metro Detroit, MI [Sterling Hts.]
Jeff in Michigan is installing the 3rd MXP right now as Im posting this. His was the one from Forged. And his is AUTO! Mine is the only one so far being fit onto an MT. Hopefully I will find out soon whether his install goes well fitment and tip wise.
Registered User
Joined: Nov 2008
Posts: 293
Likes: 0
From: Hamptons, New York
uuuugghh this sucks, so will Mackin now take back all the AT setups out there before their shipped and correct them ? this is going to add a ton of wait time i would think unless they just ship out a seperate part that corrects the problem with the current systems that are at the vendors. If i have to wait months more i might just grab an HKS, this wait has sucked as it is and now this 
