Haven't seen any way to actually pull the G37Xs 2009 motor out.

I do not have a car lift therefore, I cannot pull it through the bottom or 'drop it'

Im parting out the car. and the entire front, bumper, rads, supports, the intakes, shocks, suspension are all out / coming out..

After that, the front quarters are coming out aswell, really looking for an easy way to pull it with the transmission on aswell.

Can I even pull it from the top? I do not mind cutting anything lol

 

why not just take off the bumpers and fenders, sawzall the front support off and pull it out the front?

 

Yea, thats what Im trying to do..

 

You can still drop it out the bottom without a lift. I've done several 7th gen Civic motor pulls on a garage floor and we took it out the bottom. As long as you have an engine hoist its doable. Even then you could probably do it with just some jacks.

 

I have a 2011
Do you by chance have a rear quarter panel for sale?

 

Like Icrap stated if this is a junked chassis, eliminate anything that stands in you way.

You'll need to determine if you need the car to roll or not.

If you dont need the car to roll, cut the front and loosen the entire subframe and jank it all out. This way you can roll the engine assembly out.

If you need a roller, cut the front, remove your axles and motor mounts and pull it out from the front.

Good luck!