Show off your Sedans!
Registered Member
You can just wire brush the inside and spray primer/paint inside.
Premier Member
iTrader: (5)
Just use a small epoxy brush or q-tip and coat the inside of each lug nut with Permatex anti-seize... Its a bit tedious and time consuming, but you only have to do it once every couple of years. I had the same issue and this solved the rusting problem for me.
Registered Member
iTrader: (8)
Might just do this. the anti-seize i have is silver but that will still look better than rust
Premier Member
iTrader: (5)
Yeah, the silver stuff is what I used too. My old lugnuts were gunmetal and you really didn't notice the silver once it was brushed on. I just got tired of the rusty water dripping out every time I washed the car.
The following users liked this post:
adejong03 (06-11-2019)
The following users liked this post:
adejong03 (06-11-2019)
Administrator
iTrader: (9)
Caliper covers?