F.I. X sedan exhaust installed!
... the cross-member underneath the car... the muffler x pipe section was banging against it, so I just took it back for the guys to take off. The only reason it's there is to keep a broken exhaust from dragging/falling off. No structural benefits to it whatsoever. Some people have put washers on the bolts to space it further down, but meh. It was easier just to remove it. lol
Thread Starter
Registered Member
iTrader: (5)
Joined: May 2009
Posts: 2,256
Likes: 66
From: Chicagoish
Thread Starter
Registered Member
iTrader: (5)
Joined: May 2009
Posts: 2,256
Likes: 66
From: Chicagoish
looks great op! i've been considering an exhaust setup, but i wasn't a fan of any of the tips (tanabe, stillen, etc.). the only set i was considering was the arks, but i didn't realize how large the tips were. i'm surprised by the fi system...i didn't even really notice it around! i think i just might have my mind set!
any bumps in performance? that piping doesn't look very large...lol
any bumps in performance? that piping doesn't look very large...lol
Last edited by eksigned; Jul 1, 2010 at 05:12 PM.
Thread Starter
Registered Member
iTrader: (5)
Joined: May 2009
Posts: 2,256
Likes: 66
From: Chicagoish
LOL It's 2.5"... 
There's a definite improvement throughout the whole RPM range. It really feels like a whole different car now. It was quite a dramatic upgrade with the ERZ HFCs! The HFCs alone weren't all that dramatic, but this combination is GREAT!

There's a definite improvement throughout the whole RPM range. It really feels like a whole different car now. It was quite a dramatic upgrade with the ERZ HFCs! The HFCs alone weren't all that dramatic, but this combination is GREAT!
Efuseakay, I just got my FI exhaust put on yesterday and all i can say is WOW!!! My buddy owns a shop over here in Pa called Dreamwerks Auto Performance and said that it was the easiest and best sounding exhaust that he has put on. It looks stock but a the same time it looks MEAN. The sound is freaking awesome!!! I am currently on the 2nd hot/cold cycle. How many miles should i wait before i open this bad girl up?
Thread Starter
Registered Member
iTrader: (5)
Joined: May 2009
Posts: 2,256
Likes: 66
From: Chicagoish
You should be good to go after one more cycle. I put on close to 100 miles before I took the vids. 100 miles in a day. lol
Glad you're enjoying it! Of all the cars/exhausts I've had, this combo is hands down my favorite!
Glad you're enjoying it! Of all the cars/exhausts I've had, this combo is hands down my favorite!
Hey efuseakay, how far do your tips stick out? I'm getting some rattling under my car and a squeaking noise. I also noticed that your tips are centered in the cut outs on the back bumper. Mine are a little inward. Any ideas? Thanks in advance....
Thread Starter
Registered Member
iTrader: (5)
Joined: May 2009
Posts: 2,256
Likes: 66
From: Chicagoish
My left tip is slightly off, but I'm ok with it. You just have to play around a bit... try loosening the clamps to the muffler sections so you can turn them a bit... it's also possible the exhaust hangers were bent during shipping. You could try bending those as well, to get a better alignment.
The rattling may be the cross-member "brace" under the car up by the first muffler. I removed mine completely.

Not sure about the squeaking. Make sure everything has clearance, and is tightened up good.
Good luck!


