So after a long long journey of trying the simple task of adding wheel spacers to my wheels the journey has finally been completed! Small rundown of my problems is that i first ordered two sets of H&R DRM 15mm spacers but then realized my rear wheels didn't have divets in them for these kinds of spacers and were a flat surface so i had to reorder H&R DRS spacers with the extended studs.

I also realized my rubbing issue was horrible so had to trim my rear brackets to the absolute lowest possible amount where it wasn't necessary to remove completely and also cut about an inch off my fender lining and bolted that to the top of the fender wall. All in all it took me about a month of waiting and working till it finally got finished

To install the studs i went to my good friends brothers shop called Broadway Performance, located in Clifton NJ, and also runs an exoctic car rental agnecy outside of his shop so i had an awesome 2 hours just hanging around there and learning by helping with the new studs installation. He was also kind enough to take me for a drive in one of the lambos theres and i must say CHECKED OFF THE BUCKET LIST! Top 10 experiences of my life! IT WAS AMAZING!

Now my baby is sitting hella flush! I hope you guys like the pictures of my car as well as some other goodies I took while being there.

Wheels:
20 Vossen CV3-R
Front- 20x9 32 offset currently 17 after 15mm spacers
Rear- 20x10.5 45 offset currently 30 after 15mm spacers

BEFORE






Gotta fix that rear diffuser the bottom bolt is a little off




AFTER

 

Some of the goodies at the shop!



LP560 Lamborghini





Gated stick shift LP640 Lamborghini 1 of 16 IN THE WORLD!





Backdraft Racing Shelby Cobra









Brand spanking new Corvette Z06

 

Happy for you man. Glad it all worked out. Love the stance. Which springs are you on?

 

Thanks man! Currently sitting on the Eibach Pro KIT but plan on doing coils in the near future if all goes as planned

 

Wow, perfect choose for spacers. Those wheels are perfectly flush now. They look great Kenny, glad you were able to work it all out

 

Damn bro. Kenny that's lookin sick bro! Love the extra car pictures too. I'll be putting on your rotors you sold me soon. Hope they are killer. Should be!

 

Nice fit K, shoulda asked me what wheels sizes to run and could have avoided all this.




j/k kinda

 

My old brigade CSM had a shelby looked exactly like that one...you knew he was in a good mood when he drove it in to work.

 

Awesome G Kenny! Loving the CV3R on them, I wanted CV3 On My coupe! Very tasteful mods keep it up!

 

I think I've annoyed you enough for the whole year Brad and it's only April

 

Glad it all worked out in the end brotha.!
Congrats!

 

Car looks amazing Kenny. I knew everything would turn out ok in the end. You also got to see some pretty amazing cars through this experience so that is pretty awesome man.

 

Car looks LIT bro!
Glad you got it looking the way you wanted it!

 

I can't believe your 9" +32 / 10.5" +45 were that tucked. Came out looking good!!

 

I saw a Cobra kit car last night. It was traveling a different direction so I couldn't inspect it or find out which engine he was using.