Autokits-X V2 DIFFUSER CF with Fast Intentions
03-24-2014, 07:51 PM
#22
Registered User
looks great, I just picked on e up here in the classifieds. can you take upclose pictures of your screw points and the filament? any DIY instructions would be appreciated 
03-24-2014, 09:27 PM
#23
No, the diffuser will fit only the 2008-2013 G37 coupe X, journey or sport rear bumper.
The convertible and IPL are bumpers totally different.
The installation is very easy if you have some one to hold it in the the center part until you start peeling the red tape, to attach the 3M double side tape.
The V2 diffuser comes with 2 brackets to install them with the 2 OEM bolts located underneath of the bumper.
The V1 diffuser has 2 pre-drilled holes:
Also any diffuser comes with 2 clips.
these clips are for each corner between the bumper and diffuser (no drilling required)
Just take your time and make sure the surface of the bumper is clean without any grease.
The convertible and IPL are bumpers totally different.
The installation is very easy if you have some one to hold it in the the center part until you start peeling the red tape, to attach the 3M double side tape.
The V2 diffuser comes with 2 brackets to install them with the 2 OEM bolts located underneath of the bumper.
The V1 diffuser has 2 pre-drilled holes:
Also any diffuser comes with 2 clips.
these clips are for each corner between the bumper and diffuser (no drilling required)
Just take your time and make sure the surface of the bumper is clean without any grease.
Thread
Thread Starter
Forum
Replies
Last Post
aktif8
G's FS
9
07-02-2015 10:57 PM
