Yo Folks...

I installed the Stillen Gen 2 Tonight... It looks and works amazing...

Problem... Something messed up with I took off the battery...
My windows are F'd up... You know how they slightly open when you pull the
door handle? Well mine are F'd up...
1) Auto Up does not work... Auto Down no prob???
2) When I'm inside and park, and put up all windows, when I exit the drivers
door window goes all the way down

It is supposed to rain tomorrow... I gotta figure something out, can't miss work

 

You gotta reset them. Hold the button up for 15 seconds, then hold it down for 15 seconds. This is common when you disconnect the battery.

 

I think i read somewhere u have to reset the windows.

I am not sure but i think u hold the window button up for 30 secs and or hold down for 30 secs as well.

 

damn some one beat me well good luck.

 

Going to do it now...

 

this is incorrect. yes it will work but the correct way to reset the windows (per the manual page 2-51)

1. Push the ignition switch to the ON position.
2. Close the door.
3. Open the window completely by operating
the power window switch.
4. Pull the power window switch and hold it
to close the window, and then hold the
switch more than 3 seconds after the
window is closed completely.
5. Release the power window switch. Operate
the window by the automatic function
to confirm the initialization is complete.
6. Perform steps 2 through 5 above for other
windows.

 

I LOVE THIS PLACE... Y'all are the best!!!
Just fixed em up... Damn that was f'n weird... THANKS YOU GUYS!

My neighbor and I went for a ride after the install of the
Stillen Gen 2... OMG The intake sound is amazing!!!
I took it for a good 20 minute ride on normal cruise (Street Lights)
Then highway cruise... ***** out, pedal to the floor hoping to aid
the ECU can learn!!! Does it take a few days or a certain amount
of hours to learn???


JC

 

Any pics of the intake?

 

I'll post it tomorrow... Did take one...

 

Did you just DIY? Can you perhaps give us a quick rundown of the install?

 

Did it with my friend helping... I tried to upload the Stillen instructs PDF but it
didn't accept the upload twice??? Their instructs are good... The only beef I had
with the instructs was that the only FINAL Finished picture they have is with
the engine cover on. They should have taken one pick with all installed w/out
the cover on, so you can see how close the support tubes were. The rubber
tubing that came with the kid was big. i cut both, drivers side just a little but
the passenger side, I cut the supplied tube in half... but better bigger I guess.
Its really a clean look... Replaces the exact space your stocks took up but just
works 10x better and looks bada$$

Anyway, Attached is a picture of the finished deal... LOVE the sound when you get on it!!!