Anyone Recommend this G37s spoiler replica?
I bought a replica for my G35 C. It fit perfect and the paint matched perfect. It was fine for 2 years until I sold the car.
Since this is a lip I seriously doubt that you would have problems with sagging in the middle.
With regard to painting- as long as they have the right paint code it would be dificult to be "100% off"... maybe 5% but probably not too noticeable depending on the color choice.
Since this is a lip I seriously doubt that you would have problems with sagging in the middle.
With regard to painting- as long as they have the right paint code it would be dificult to be "100% off"... maybe 5% but probably not too noticeable depending on the color choice.
Be careful! I love the spoiler look so I bought my car w/one. I have done the ebay ones in past w/mixed results. I got one for an IS300 in metallic Pearl White and it looked ok paint wise, good fit and finish...but the 3rd brake light leaked so it shorted out...what a mess...and I also did one for my nonmetallic White Mustang GT...you could tell it didn't match. No fault to the place, job was excellent...just hard to match based on codes.
If anything, w/our paint, I'd recommend buying an unpainted one and take it to a reputable shop to match and perhaps install. Just my .02. Cheers
If anything, w/our paint, I'd recommend buying an unpainted one and take it to a reputable shop to match and perhaps install. Just my .02. Cheers
i just recieved one of the replica's from ebay, it looks okay to me, didnt fit it on as yet...too cold. Paint's fine, Comes with screws and all. going to post a picture up + the length of it, maybe someone can take a measurement of there OEM one to see if its exact. Its very light by the way.




the brake light cut out is a bit off look at both ends, wing is about 47 or 48 inches from tip to tip
edit: fitted the brake light up, fits perfectly, had to shave the camera hole a bit because one end was a straight cut and one end had a non straight cut, like it was not fully cut down.




the brake light cut out is a bit off look at both ends, wing is about 47 or 48 inches from tip to tip
edit: fitted the brake light up, fits perfectly, had to shave the camera hole a bit because one end was a straight cut and one end had a non straight cut, like it was not fully cut down.
Thread
Thread Starter
Forum
Replies
Last Post
SpeedBallDEVIL
Private Classifieds
3
Aug 12, 2015 04:30 PM




