Dear
I'm from Switzerland and here we have only a view G37 Convertible....
Now, i have than some Adjustments on the Roof and for this i have opened the Roof to the half open Position. And now my mistake i turned the Engine off...
After the Lunch-Time i'll by back and saw that the Roof was moved to the Trunk....
So i turned the Engine On and press the Switch to Close the Roof but it doesn't Works.

Then i saw that the Parcel is in the Down Position (Sensor Endposition).
Now in this Position the Hydraulic will not Work for the Roof, because the Parcel must by 2/3 Up and then the Hyraulicpump will work....


Now my Question:
Is it possible over OBD2 (Consult-III) only the Parcel (see on the Factory Service Manual / Page RF-39) to Control...

Maybe it gives also a other way...


Thanks for all Supports that help's my....
Best Regards
Eric

 

eek. This is a tough one. I'd try the troubleshooting steps in the manual and FSM:
Infiniti G37 and Q60 Convertible Manuals and Guides
One of these might work for you.

 

Dear
Thanks for your Information. Yesterday i'll have than this Procedur over the Consult III.
So after two Hours of Time and new Learning the Roof works.....
But now the middle Section of the Roof have some Scratches and this must by new Paint....
Best Regards
Eric