Help Changing Power Steering Pump
#1
Registered Member
Thread Starter
Changing Power Steering Pump
Good afternoon everyone.
So long story short, my old block gave out and I bought a used VQ37 out of a crashed 2013 G37X and built it with forged CP Pistons and Carrillo Pro H-Beam Forged Connecting Rods. So far, everything has fit perfectly, including the manual transmission. However, the power steering pump bracket that came off the old block is ever-so-slightly off (I'm using my power steering pump from the old block as well). It could be that the bracket is just bent but I'm asking here because idk if there's a piece of the puzzle that I'm missing from all this. Let me know if anyone has any insights.
So long story short, my old block gave out and I bought a used VQ37 out of a crashed 2013 G37X and built it with forged CP Pistons and Carrillo Pro H-Beam Forged Connecting Rods. So far, everything has fit perfectly, including the manual transmission. However, the power steering pump bracket that came off the old block is ever-so-slightly off (I'm using my power steering pump from the old block as well). It could be that the bracket is just bent but I'm asking here because idk if there's a piece of the puzzle that I'm missing from all this. Let me know if anyone has any insights.
The following users liked this post:
slartibartfast (07-27-2018)
Thread
Thread Starter
Forum
Replies
Last Post
tsiripong2000
G37 Sedan
10
11-14-2014 12:36 PM
hydronos
Private Classifieds
1
07-31-2014 09:26 AM
who4ever
Engine, Drivetrain & Forced-Induction
8
10-27-2011 01:26 PM