engine swap compatibility
#1
engine swap compatibility
You might remember I made a post about blowing my engine a little while ago. The cars been sitting on the side of my house since, being that I have a daily and a work vehicle I haven't had much interest in rushing to fix it. My car is 6mt rwd and I found an engine locally but the donor G is awd, and auto...does anyone know exactly what I would need to swap over to make it work other than the input shaft I would be swapping the entire long block. I've been looking and all I found so far is the oil pan is shaped differently so I would need to swap that.
Any other info would be greatly appreciated!!
Any other info would be greatly appreciated!!
Last edited by big nick; 12-12-2015 at 09:45 AM.
#2
Pan is different to make room for transfer case , you should be fine tho lay the engines side by side so you can "groom" the new ones you will have to swap the flywheel and any other components that are not the same as your original.
Thread
Thread Starter
Forum
Replies
Last Post