TVPostSound

iTrader: (9)

Installed these today to replace the SPC arms.
The SPL traction arms needed company!!

Then drove the **** out of it to let my diff bushing blow completely, thats another story on another post!!

blnewt

iTrader: (13)

Nice beef back there, too bad about the bushing, better tone it down a bit
TVPS

TVPostSound

iTrader: (9)

Tone it down? Pun intended?

I have a DIY starting for the diff bushing, was going to start it this weekend, but procrastinated due to these expensive arms sitting on the bench!!

BTW, with both Camber and Traction arms installed there is no more NVH than before with heim joints, but rear end response is amazing, much easier to control if I want more or less oversteer!!

NeverBoneStock

iTrader: (25)

What kind of difference if any did you notice after installing the SPL parts ??

TVPostSound

iTrader: (9)

Previous post ^^^^