New suspension setup
Thread Starter
Registered Member
iTrader: (6)
Joined: Jan 2012
Posts: 249
Likes: 4
From: Orange County, CA
New suspension setup
Look what just arrived. Can't wait to get these installed. Would I need to get a camber kit? Planning on putting 20" wheels on.
Update 4/29/12
Added pix of measurments
Swift

KONI Sport Yellows



Front

Rear

Front

Rear
Update 4/29/12
Added pix of measurments
Swift

KONI Sport Yellows



Front

Rear

Front

Rear
Last edited by dtran2714; Apr 29, 2012 at 08:11 PM. Reason: updated pix
So jealous! Write up a review when you get some miles on it as this will be my route too! I've got camber kits just cuz I'm pretty **** about these types of things. It's got a similar drop as eibachs so I would say you'll just be outside of camber specs without them.
Nice!!
Make sure whomever installs the Konis does NOT use an impact gun on the strut nuts. They must be done by hand!!
The nuts are not the locking type, so it should be no issue.
You're #3 G37 with Konis, Im #2, Speedbump was #1 (test fitter at Koni!!
Make sure whomever installs the Konis does NOT use an impact gun on the strut nuts. They must be done by hand!!
The nuts are not the locking type, so it should be no issue.
You're #3 G37 with Konis, Im #2, Speedbump was #1 (test fitter at Koni!!
Thread Starter
Registered Member
iTrader: (6)
Joined: Jan 2012
Posts: 249
Likes: 4
From: Orange County, CA
Thanks for the advice....debating on installing it myself or take it to a shop.
Thread Starter
Registered Member
iTrader: (6)
Joined: Jan 2012
Posts: 249
Likes: 4
From: Orange County, CA


