wait a minute you have 20's and rubbing already without any drop?

 

yeas when i go over the bumps thats when they rub just the back once and i have the H&R springs but haven't put them on yet im afraid it'll rub even more

 

What is the offsets on your wheels??? Because i'm pretty sure you have the wrong offsets... Man the h&r springs will drop your car 2 inches and your camber is gonna be like 3 degrees negative front and rear.. That will wear your tires out extremely fast..

 

im not sure what offset they are i used to have them on my g35

 

you will ,, as in YOU WILL rub more with the H&Rs ,, those springs are low!
i agree with JKS ,, i think its the offset ,, i have 20's , dropped on htechs ,, same tire size as yours,, and dont rub even in deep pot holes

if you dont mind ,, what wheels do you havE?

 

Yeah then I know the offsets are your problem then because with the g35 u could run a real aggressive offset with no problem.. I have a 35mm offset in the front and a 37 mm offset on my volks. They fit flush with the fenders, they sit beautifully.. I have 245/35/20 in the front and 275/30/20 in the rear.. I have the Tanbe nf210 springs and I have no problems with rubbing at all.

 

i think my offsets are front Size: 20x8.5,Bolt Pattern: 5x114.3 Offset: 20 and rear Size: 20x10,Bolt Pattern: 5x114.3,Offset: 25

 

i think with the G , you need atleast plus 30 offset wise,,,, mine are plus 35 and plus 37

 

so there is no way of fixing it maybe rolling the fenders other than changing the wheels

 

i also encountered one member here in the forum ,, his name is oneniceG i think,,, he also used his volkS from his g35 to his 37 ,,, i think he had rubbing problems as well ,, he installed his tanabe's only on the front because he will rub more if he did it in the rear

 

in regards to rolling fenders,, i dunno about this one ,, our fenders are rolled already ,, hmmm i never rolled fenders before,, but if you will ,, atleast go to a professional to do it ,, it could ruin your paint ,, but i dont recommend rolling fenders ,, just my opinion

 

so the best bet is to sell the wheels and get new once

 

well
wut i did was, i pulled the fenders. i did it at corner 3 garage.
they know what they were doing. cant guarantee that they will do a great job, but they did mine great. i had +15 all around on 19s and they did a great job.
gluck.

 

hmmm yeah so pull fenders or get new wheels .,, your choice ,, what wheels do you have?

 

Yeah, he had 19 inch Volk GT-7s. They're +15 all the way around I believe. He was able to lower the front on tanabe's but he wasn't able to lower the rear.