When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
The thread I posted shows that I used (2) bolt/nut/spacer per corner and it not only helps secure it but helps pull it flush to the bumper if needed (mine did just a little).
Originally Posted by IvoryGT
Perhaps additional nut and bolt with washers would be needed to reinforce the install.
Special thanks to PFizzle for letting me borrow his old headlights so I could remove mine. Now, I can finally send mine out to Igor and have the V2 mod and CF housings installed. I wasn't able to get the passenger side of the bumper on perfect. I do need to readjust it but I won't be bothering until after I get my lights back.
After a lot of modifications (jigsaw and dremel) the Splitter is finally on. Stillen fitment definitely has room for improvement. If I didn't spend so much money on it and it didn't look SO sweet (after IvoryGT wrapped it for me) I probably would have sent it back to Stillen. Pictures will be up tomorrow at some point.
