I been trying to modify my headlgihts by painting the inside and i havent been able to find a place that does it and i finally found a place and is there a catch to doing it? like i heard the headlight cover will fog or something

 

They will bake the lights to loosen the glue and pry them apart to paint them. The key to avoiding condensation is to make sure they are properly sealed back up when they are putting them back together. an incomplete seal will cause them to fog up.

 

If the paint is not cured long enough before you put them back in and seal , it might haze from the gases..

 

where are u located?

 

theres a few members on the forum that do this, some for a living.

where you at?

 

so cal??? if so ask ucla bruin!

 

^or ig0r if you're on the east coast. make sure the shop knows what they're doing as these are really expensive lights.