Can anyone tell me what front lip this is? and if it's not a lip kit what is it exactly? I PM'd the owner of the car but havent gotten a response. Never seen it before...

 

Looks like a custom piece, it looks like its angled upward

 

custom for sure.. the guy is on the forums. first time i've seen it. it does look angled upward. would probably look better if straight.

 

pretty sure its the stillen splitter painted white

 

I kinda like it angled like that, gives a little "flavor"

If its the stillen front splitter, wheres the metal bars that hold it in place? and does the stillen splitter sit straight not angled? i guess he could have molded it to the bumper..

 

idk what that is looks custom i like

 

forget the lip, what RIMS are those?!

 

Stillen Splitter white.

 

DPE GT6

Like I said above, wheres the metal bars holding it in place and whys it slanted?

 

Definitely Stillen splitter, painted white. There's someone else on this forum who installed it without the turnbuckles and says the splitter is doing just fine.

 

Yeah that looks exactly like the Stillen splitter. I have it on my car.. You can install it without the turnbuckles, but the turnbuckles do extra reinforcement and allow you to adjust the angle of it... To cut through the air better...

 

Nice, thanks for chiming in. I thought the turnbuckles were required but I guess I was wrong. So if I didnt use the turnbuckles how would I get it tilted like that then?

 

looks like it just follows the angle of the bottom of the bumper that way

i guess you can screw it on or use double sided tape. if you want to change the angle, use thicker tape on one side, or use spaces if you screw it on

 

Don't know about that. I have the turnbuckles on mine because they really help stiffen it up big time. My splitter has two way tape and 10 screws underneath along with the turnbuckles. So it's nice and rigid.... The turnbuckles are where the adjustments at for raising or tilting it....

 

car doesnt look to bad..