Stealth install, almost finished
11-06-2008, 03:29 PM
#1
Registered User
Thread Starter
Stealth install, almost finished
Here is what I got (so far):
Just a trunk, right?
Remove the top trunk mat:
Remove the inner mat and now we got something
They are a DLS A4 for the tweeters and mids (4 ch), a DLS A3 (dual mono) for the mid bass, and a DLS A6 (mono) for the subs. No rear fill!
An AudioControl LC8 LOC hooked up to the factory head unit
A closer look
The processor, an Alpine PXA-H701 is tucked in there
But were are the subs? I actually have 4 x 10's stashed in the side panel on both sides of the rear sit. That is one on one side, but there is another one just below it
A detail of how the two subs are laid out on each side. Sorry for the picture buy I did not want to remove the side panel. I have posted pictures of the side panel on here before, you should be able to find them
A close up of one of the four subs, a DLS OA10. Yeah, I messed up the outter seal but I do not need it in this setup.
The speakers are a set of Hybrid Audio Technology Legatia L831 that are hidden in the doors for a factory look. I may remove the panel and take some pictures later. I did not feel like doing all that today
Like I said, I kept the factory head unit for the stealth look
This is the sunglass compartment. Eventualy I will replace all the interior (beige) upholstery to black upholstery. I kind of started with the sunglass compartment just to test the plastic dye. If it holds I will do the whole thing.
But when you open it you have this beauty, this is te RUX-C701 that controls my processor
Those are all the pictures for now. I still have some stuff left to do and the job is not finished yet.
Yes, it sounds very nice but it still needs some fine tuning.
Enjoy!
FC
Just a trunk, right?
Remove the top trunk mat:
Remove the inner mat and now we got something
They are a DLS A4 for the tweeters and mids (4 ch), a DLS A3 (dual mono) for the mid bass, and a DLS A6 (mono) for the subs. No rear fill!
An AudioControl LC8 LOC hooked up to the factory head unit
A closer look
The processor, an Alpine PXA-H701 is tucked in there
But were are the subs? I actually have 4 x 10's stashed in the side panel on both sides of the rear sit. That is one on one side, but there is another one just below it
A detail of how the two subs are laid out on each side. Sorry for the picture buy I did not want to remove the side panel. I have posted pictures of the side panel on here before, you should be able to find them
A close up of one of the four subs, a DLS OA10. Yeah, I messed up the outter seal but I do not need it in this setup.
The speakers are a set of Hybrid Audio Technology Legatia L831 that are hidden in the doors for a factory look. I may remove the panel and take some pictures later. I did not feel like doing all that today
Like I said, I kept the factory head unit for the stealth look
This is the sunglass compartment. Eventualy I will replace all the interior (beige) upholstery to black upholstery. I kind of started with the sunglass compartment just to test the plastic dye. If it holds I will do the whole thing.
But when you open it you have this beauty, this is te RUX-C701 that controls my processor
Those are all the pictures for now. I still have some stuff left to do and the job is not finished yet.
Yes, it sounds very nice but it still needs some fine tuning.
Enjoy!
FC
Last edited by fcarpio; 11-06-2008 at 03:40 PM.
11-06-2008, 03:46 PM
#4
Registered User
Thread Starter
It sounds nice, the bass drops quite a bit. As you can see in the processor picture I am only using the subs for 50Hz and below. The Legatia's mid bass is an 8" and puts out some really nice midbass. Since I am runing active I have to do a lot of tweaking, such as crossover points, eq per speaker, that is 5 (tweets and mids go together for two channels, midbass for two more channels, and sub single channel) different eq settings per channel with 31 channels each.
Trending Topics
11-06-2008, 05:08 PM
#14
Registered User
Thread Starter
There is MDF in the baffle, topped with a sheet of aluminum. If you search here you may find the older pictures before it was painted. Anyway, the whole thing is going to be covered with a panel. In the end, nothing is going to show.
