FS 2008 G37S Twin Turbo R34 Bayside Blue
#1
Registered Member
Thread Starter
2008 G37S 6spd Twin Turbo R34 Bayside Blue
Year: 2008
Make: INFINITI
Model: G37 Coupe
Price: $24000
Mileage: 24500
Color: Bayside Blue
Private or Dealer Listing: Private Listing
Location (State/Prov): PA
Engine/etc:
GReddy TD06SH-20G (x2) Twin Turbos
GReddy Exhaust Manifolds
GReddy Downpipes and Exhausts
GReddy Type-T Wastegates
GReddy Blow off valves
GReddy Type-29 R-Spec Intercooler
aFe Power Air Filters
DeatschWerks 600 cc/min Injectors (x6)
Samco Sport Hoses
Bosch 044 Fuel Pump
UpRev Osiris
Blitz SBC I-Color
Blitz Throttle Control
HKS Spark Plugs
ARC Oil Cooler
M7 JAPAN Oil Cap and Radiator Cap
Mishimoto Radiator
SPEC Competition Clutch/Flywheel Stage 3
Greddy short shifter/****
Suspension/ETC:
M7 JAPAN Super Performance Dampers
M7 JAPAN Springs 10kgf/mm & 8kgf/mm
CUSCO Strut Bar (F)
GT SPEC Underbraces
Whiteline Sway Bars
Custom end links
Brembo 6 Piston Calipers
Brembo 15" Rotors
Project Mu Teflon Coated Braided Lines
RAYS Gram Lights 57 Extreme19x9.5 19X10.5
Custom 2-inch Wde Rear
Exterior:
R34 Bayside Blue complete paint job
Custom Vented Carbon Fiber Hood
Carbon fiber trunk
Carbon fiber roof overlay
AIT Custom bumpers/skirts
Interior:
Complete Morel supremo interior components
Zapco 1000.4 Amp
Zapco 750.2 Amp
2 Image Dynamics IDMAX subs
Custom trunk set up
Navi Bypass
Stinger battery in trunk
Carbon shroud on steering wheel/dash
3M blue metallic interior pieces wrapped
Last edited by mynes; 04-28-2017 at 08:52 AM.
#5
Registered Member
Thread Starter
You are 100% right sir!!!! Ding Ding Ding. But I'm on 7psi at the moment until engine break in... You know your stuff
#7
Registered Member
Thread Starter
Why would I have pictures of the motor rebuild? I didn't rebuild it the shop did. The engine was rebuilt from top to bottom even a new block so I would think new gaskets would have been used.
Trending Topics
#9
Registered User
iTrader: (2)
Engine/etc:
GReddy TD06SH-20G (x2) Twin Turbos
GReddy Exhaust Manifolds
GReddy Downpipes and Exhausts
GReddy Type-T Wastegates
GReddy Blow off valves
GReddy Type-29 R-Spec Intercooler
aFe Power Air Filters
DeatschWerks 600 cc/min Injectors (x6)
Samco Sport Hoses
Bosch 044 Fuel Pump
UpRev Osiris
Blitz SBC I-Color
Blitz Throttle Control
HKS Spark Plugs
ARC Oil Cooler
M7 JAPAN Oil Cap and Radiator Cap
Mishimoto Radiator
SPEC Competition Clutch/Flywheel Stage 3
Greddy short shifter/****
GReddy TD06SH-20G (x2) Twin Turbos
GReddy Exhaust Manifolds
GReddy Downpipes and Exhausts
GReddy Type-T Wastegates
GReddy Blow off valves
GReddy Type-29 R-Spec Intercooler
aFe Power Air Filters
DeatschWerks 600 cc/min Injectors (x6)
Samco Sport Hoses
Bosch 044 Fuel Pump
UpRev Osiris
Blitz SBC I-Color
Blitz Throttle Control
HKS Spark Plugs
ARC Oil Cooler
M7 JAPAN Oil Cap and Radiator Cap
Mishimoto Radiator
SPEC Competition Clutch/Flywheel Stage 3
Greddy short shifter/****
was lookin at your list.. parts that would normally be listed on a performance build would be things like..
pistons.. rods.. bolts.. boring.. etc
you also cant assume that certain things were installed.. they wont necessarily know to replace it with a newer part...
or worse.. reuse to skimp on cost... just sayin.. it helps with your sale to know what was done..
car looks good.. and no doubt its stout.. but as a buyer.. every info counts
Last edited by micafd3s; 04-13-2017 at 06:01 PM.
#11
Registered Member
Thread Starter
#12
Registered Member
Thread Starter
curious as to why it was rebuilt for such low mileage..
was lookin at your list.. parts that would normally be listed on a performance build would be things like..
pistons.. rods.. bolts.. boring.. etc
you also cant assume that certain things were installed.. they wont necessarily know to replace it with a newer part...
or worse.. reuse to skimp on cost... just sayin.. it helps with your sale to know what was done..
car looks good.. and no doubt its stout.. but as a buyer.. every info counts
was lookin at your list.. parts that would normally be listed on a performance build would be things like..
pistons.. rods.. bolts.. boring.. etc
you also cant assume that certain things were installed.. they wont necessarily know to replace it with a newer part...
or worse.. reuse to skimp on cost... just sayin.. it helps with your sale to know what was done..
car looks good.. and no doubt its stout.. but as a buyer.. every info counts