K&N Panel Engine Air Filter
 

So I was changing out my engine air filters from cheap old disposable air filters for K&N filters but while i was trying to put the part back into the air box it was quite hard to push the metal connectors back on. I was wondering if anyone else had this same experience or if i should check something out. the regular old ones went back in fine but i dont really know why the new ones were harder to put in. maybe just cause im inexperienced
https://cimg7.ibsrv.net/gimg/www.myg...258f8ba93.jpeg

That is normal, same thing on my car. The rubber around it just a bit thicker so crap does not go around the edges, but more through the filter it self. Also make sure that when you oil them up do not use a lot of oil or it will leak out through the holes of the air filter housing from the bottom and get all over the inner fenders. Don't ask how i know lol.

Poor quality control on aftermarket parts most likely made in China?
I'm on my third Infiniti and never had that problem over the past fourteen years and over 300k miles. I change my air filters roughly every 10k miles
Then again I only use OEM air filters that I purchase at the dealer and get my 10% discount, sometimes more.

Telcoman

No, K&N is manufactured and designed in Riverside. has thicker rubber seal than OEM