Official Low Offset/Hellaflush Thread
#2206
I personally would swap them out to a 255/35/19 and lower a little more, that would help a lot.
#2207
Registered Member
iTrader: (1)
Originally Posted by xmajd92
Yeah I was afraid of reading that answer lol. I don't want too much camber so I'll just put my Weds Sports back on and resell them lol.
#2209
Hey you guys, I have my G coupe lowered on the Eibach springs and I don't have a camber kit. My camber is -1.79 and -1.68 in the rear. I found a set of wheels I'd like that are 19x9.5 and 19x10.5 +25. Will these wheels fit at the specs I'm at? If not, what would it require me to do? What would be the tires I'd need to run?
#2210
Originally Posted by Datez
Hey you guys, I have my G coupe lowered on the Eibach springs and I don't have a camber kit. My camber is -1.79 and -1.68 in the rear. I found a set of wheels I'd like that are 19x9.5 and 19x10.5 +25. Will these wheels fit at the specs I'm at? If not, what would it require me to do? What would be the tires I'd need to run?
The following users liked this post:
b-drizzy (08-03-2017)
#2212
On my Sedan I've been rocking zero'd out camber in the rear and 2' up front for a while now and am curious how much camber one can run and still get decent tire wear as long as toe is good?
Of course zero camber is what someone would want to get perfectly even tire wear but what I'm asking is how much camber can I run and still get "acceptable" tire wear? At what negative degree does it go off the deep end?
I want to start running some negative camber to get a more stanced flush VIP look.
I was thinking 4 degrees in the rear and 3.5 up front? Nothing crazy but a wider look.
Currently running:
20x9x10
245/35/20
285/30/20
Thoughts?
Of course zero camber is what someone would want to get perfectly even tire wear but what I'm asking is how much camber can I run and still get "acceptable" tire wear? At what negative degree does it go off the deep end?
I want to start running some negative camber to get a more stanced flush VIP look.
I was thinking 4 degrees in the rear and 3.5 up front? Nothing crazy but a wider look.
Currently running:
20x9x10
245/35/20
285/30/20
Thoughts?
Last edited by Tones11; 08-29-2017 at 11:04 PM.
#2216
Registered Member
iTrader: (1)
I'am running -6 in rear and -3 front, I'm low enough where my key fob don't go under my car lol
19x10.5 +22 rear 245/35
19x9.5 +12 front 225/35
it all depends how low you want to be, running camber only makes sense if your riding low, you don't want to add camber if your not low, and depends how wide you want to run your setup all that comes into play..
19x10.5 +22 rear 245/35
19x9.5 +12 front 225/35
it all depends how low you want to be, running camber only makes sense if your riding low, you don't want to add camber if your not low, and depends how wide you want to run your setup all that comes into play..
#2217
My figment numbers
This is my g37x 2009 coupe. It's got square (well not really because of the spacers) setup. Front +38 f1r f35 20x10 255/35/20 with 15mm spacers. Rear is the same setup except the spacers are 20mm. So technically the offset is 23mm in front and 18mm in rear. It's also got eibach lowering springs on it. Nothing rubs. Sits perfectly with that big booty. Hope I can help some one with these numbers.
#2218
Registered Member
Here is a new challenge
2011 G37 sedan upgraded to BBK
Wheel sizes as below
20X9 (F) et 15
20X11.5 (R) et 20
I know I will be running a lot of negative camber and might have to roll the fenders but what tire size do you guys think I can get for the front and rear- I would like to fit the widest tire possible - I am ordering my coilovers suspension soon so want to know my tire size options in advance.
And if anyone has ever ran a similar setup, let me see it
2011 G37 sedan upgraded to BBK
Wheel sizes as below
20X9 (F) et 15
20X11.5 (R) et 20
I know I will be running a lot of negative camber and might have to roll the fenders but what tire size do you guys think I can get for the front and rear- I would like to fit the widest tire possible - I am ordering my coilovers suspension soon so want to know my tire size options in advance.
And if anyone has ever ran a similar setup, let me see it
#2220
Registered Member
I'm trying not to run stretch tires - But I don't think I have another option.
Maybe I should just sell the rear set and get something less aggressive?
What is the widest tire sizes I can get away with without hitting any of the control arms and fender liners lol
P.S - I love the stance on your car. It looks perfect to me but I don't think without bags mine can look that good
Maybe I should just sell the rear set and get something less aggressive?
What is the widest tire sizes I can get away with without hitting any of the control arms and fender liners lol
P.S - I love the stance on your car. It looks perfect to me but I don't think without bags mine can look that good