Cleaning the Volk Gt-30's
 

How do you clean that little area underneath each spoke that remains dirty after washing with a wash mit cause it doesn't quite reach it??

I have a method, but before I reveal it, I wanted to know if anyone else is doing it the same way on the same wheels or any wheels that have a similar hard to reach area... These pics define the area I'm referring to.

http://i156.photobucket.com/albums/t...7/P1030617.jpg
http://i156.photobucket.com/albums/t...7/P1030618.jpg

I have a very thin cloth that slides up underneath the spoke that clean it very well.

Q-tip might work....

lol, yeah Q-tips would work, very, very slowly, fingers would probably start to hurt by the 3rd wheel and you'd need a buttload of them!

Anyone else have an efficient method??

Thanks, but I know all about how to wash and keep them clean, I just had a specific area of a specific wheel that's hard to reach/clean in question...
I scanned the SEVEN pages in that thread and didn't see my issue addressed whatsoever, did I miss something?

Umm you have a method but wont reveal it? I don't get it....?

i'm feelin' the Q-tip method....

I'm waiting to see if anyone does it the exact same way and I'm allowing ample time for responses...Check back tomorrow for my method. :thewave:

My method for getting that area of the wheel clean is an improvement on the "very thin cloth" approach that Blackjack uses. Using a small micro fiber towel from Costco, I cut my own custom shaped cloths that are very thin at each end to make insertion a breeze but I go very wide in the middle so when I pull it back and forth, it cleans top to bottom, side to side, all at the same time. I can clean two spokes at a time this way. Simple, but ingenious IMO, something you can’t buy, you just make the right size at home. I do this last after spraying with a pressure washer, then a soap and water scrub with a wash mit, rinse and then dry with an air hose, which just leaves me with a little dirty/brown area under each spoke left to clean.

http://i156.photobucket.com/albums/t...P1030616-1.jpg
http://i156.photobucket.com/albums/t...7/P1030621.jpg
http://i156.photobucket.com/albums/t...P1030622-1.jpg

↑ Another simple/good idea, like using a medium size needle with some pliers ↓ to open/widen the place where you’re trying to insert your invisicord/stealthcord probes…

http://i156.photobucket.com/albums/t...7/PB250108.jpg

BJ knows best! :thewave:

Yes I do! :hello:

for a second there i thought those were some panties

microfiber panties! :BOUNCE:

so was there a sale at costco on the towls or something cause my dad has a big pack and a couple of other random people have the exact same ones