FS CNC bored 63mm OEM throttle bodies!!
#46
Registered User
Thread Starter
#47
Registered User
Thread Starter
The following users liked this post:
Synolimit (09-10-2014)
#49
Registered User
Thread Starter
Sounds good! All prices are posted. You can pay now, get a refund later or ship your OEM parts now and just pay for porting.
#51
Registered User
Thread Starter
#53
Registered User
I have Lth, stillen gen 3 intakes, 2.5in true dual exhaust, ur pulley, motordyne manifold, uprev tune. I made 295whp on a dyno dynamics dyno. Do you think I could make some more ponies with these?
The following users liked this post:
Synolimit (09-14-2014)
#55
Registered User
Thread Starter
I'd hope so. If not better throttle response and smooth flow of your intake system.
#58
Registered User
Thread Starter
370z 50-100mph tread. Everyone post. - Nissan 370Z Forum
So my dyno and 1/4 mile all suck but at least I have some power to prove from all this!! This tells me my dyno reads low and my tires suck for the strip. I'm getting 6.5 seconds on the vid and that's with my tires chirping in 2nd. I figure that's a good tenth or two right there if i can get them hotter. This is ZL1 and C63 AMG territory so woohoo for only 302rwhp.
synolimit, 2013, Nissan, 370z, 3200*, 3.7, 6 Cyl, All Motor, NA, 93, 302, 244, 14.0, 105.5, 6.5
So my dyno and 1/4 mile all suck but at least I have some power to prove from all this!! This tells me my dyno reads low and my tires suck for the strip. I'm getting 6.5 seconds on the vid and that's with my tires chirping in 2nd. I figure that's a good tenth or two right there if i can get them hotter. This is ZL1 and C63 AMG territory so woohoo for only 302rwhp.
synolimit, 2013, Nissan, 370z, 3200*, 3.7, 6 Cyl, All Motor, NA, 93, 302, 244, 14.0, 105.5, 6.5