|
--ALL SOLD, THANK YOU!-- Aftermarket & OEM Part Out
My 2015 Q40 was totaled so I have a small collection of aftermarket parts that need a new home.
Feel free to post or PM with any questions or reasonable offers. Shipped prices are within the US only, I will ship internationally if needed at Buyer's cost. SOLD STUFF: ***SOLD*** Rear Diffuser Panel by TBW Performance - $100/shipped ***SOLD*** Made out of aluminum, it replaces the rear plastic panel and looks a lot better doing it. Fits 07-08 G35, 09-13 G37, and 2015 Q40 sedans. A few fins have edge scrape damage from a bad driveway exit angle but some touch up paint made it unnoticeable unless you're right up on them while laying on the ground. This is boxed and ready to ship. ***SOLD*** Top Speed Pro 1 Y-Pipe Back Exhaust - $250 + shipping. Pick up is preferred but this setup is boxed and ready to ship if needed. ***SOLD*** If you're looking for something that is louder than stock but is not obnoxious or raspy and has no drone at cruise, then this is the exhaust you're looking for. All cleaned up and ready for a new home. Because of the size/weight I would prefer local pickup and I am willing to meet within a reasonable distance, but will ship if needed. ***SOLD*** Ultra Racing Solid Shock Tower Brace - $100/shipped ***SOLD*** The changes with this were mainly noticeable during quick turns and at lower speeds. Solid design prevents flex/movement seen with 3-piece STBs where they bolt together. This is boxed and ready to ship. ***SOLD*** GT-R Start Button modded by Gabe (grojas112) - Fits G37 & Q40 (not sure about G35) - $45/shipped ***SOLD*** Just the button is included, no trim ring, etc. Lock is Red, Acc is Yellow, On is Green (second photo shows each position) ***SOLD*** Diode Dynamics Tail as Turn Modules - $50/shipped ***SOLD*** Fits G35, G37, & Q40 ***SOLD*** Fortin EVO-NIST1 Remote Start System - $70/shipped ***SOLD*** This was installed for only 2 weeks prior to my car being totaled and it was amazing to have, I'll be getting one for my new car asap. Everything is intact and no wiring was damaged in the removal. It is currently programmed to my Q40 but because I have the Fortin Flash Link I can reflash it to whichever model you have (the NIST1 harness fits 2007+ G35/G37/Q40, plus other Nissan/Infiniti models listed here: https://fortin.ca/en/products/evo-rs.../vehicles.html). ***SOLD*** OEM Paddle Shifters & Shroud Kit - $220/shipped ***SOLD*** Probably one of my favorite interior additions and super easy to install as our cars are factory prewired for these. The paddles have some slight edge wear (pictured below), but this was present when I purchased them and they did not get any worse. The shroud kit (for manual tilt wheel) is intact with no broken pieces. Hardware to mount the paddles is included, plus hardware for the shroud in case you have any missing. The shroud bolt covers are also included, just not in place for pictures. ***SOLD*** USA Spec BT45-INFI Bluetooth Adapter - $100/shipped ***SOLD*** Uses/intercepts the satellite tuner to allow Bluetooth connection to the radio, it doesn't prevent use of the satellite radio. The Q40 had no RCA, USB, etc. inputs, so this was the best solution. Compatibility chart here: https://m.media-amazon.com/images/I/81oljUZwzFL.pdf (Infiniti section is bottom of page 2). ***SOLD*** Mishimoto Silicone Intake Tubes & aFe Drop In Dry Flow Air Filters - $175 ***SOLD*** Four T-bolt clamps included. Butt dyno said these made a slight increase in power but they definitely sounded better, plus no heat soaking like short air intakes. Cleaned and ready to go. ***SOLD*** OEM 2010+ G37/Q40 Non-Sport Front Lip - $250 ***SOLD*** This is brand new, never installed. Factory painted in Moonlight White (QAA). Includes instructions, hardware, and mounting template. ***SOLD*** OEM G37/Q40 Trunk Lid Spoiler - $150 ***SOLD*** This was installed & removed, so replacement of the 3M mounting tape will be required. Factory painted in Moonlight White (QAA). Includes hardware and mounting bracket for the camera and trunk release button. |
Interested in the remote start, dm sent
|
Intake setup is now sold!
|
check out https://www.pirateship.com/ for shipping
|
I use Pirateship exclusively, still can get up there in pricing for exterior parts though.
|
Willing to ship the turn as tail? I知 interested.
|
I知 interested in the button as well as the tail as turn if still available
|
Originally Posted by Cdai
(Post 4323644)
I知 interested in the button as well as the tail as turn if still available
------------------------------------ Updated some pricing and added shipping costs to the pieces that are easily shippable. |
Remote Start and Paddle Kit are both sold!
|
Quick bump for some modified prices.
|
Front Lip sold! Original post updated with what remains!
|
interested in BT45-INFI.
|
Interested in the BT45-INFI and GTR button if still available. Dropped you a DM!
|
Push to Start button and Bluetooth module have sold! Original post has been updated with remaining items.
|
Bump. I've added my exhaust to the listing.
|
Interested in Y pipe and exhaust
Originally Posted by RotorNutFD3S
(Post 4323332)
My 2015 Q40 was totaled so I have a small collection of aftermarket parts that need a new home.
Feel free to post or PM with any questions or reasonable offers. Shipped prices are within the US only, I will ship internationally if needed at Buyer's cost. ***SOLD*** GT-R Start Button modded by Gabe (grojas112) - Fits G37 & Q40 (not sure about G35) - $45/shipped ***SOLD*** Just the button is included, no trim ring, etc. Lock is Red, Acc is Yellow, On is Green (second photo shows each position) ***SOLD*** Diode Dynamics Tail as Turn Modules - $50/shipped ***SOLD*** Fits G35, G37, & Q40 ***SOLD*** Fortin EVO-NIST1 Remote Start System - $70/shipped ***SOLD*** This was installed for only 2 weeks prior to my car being totaled and it was amazing to have, I'll be getting one for my new car asap. Everything is intact and no wiring was damaged in the removal. It is currently programmed to my Q40 but because I have the Fortin Flash Link I can reflash it to whichever model you have (the NIST1 harness fits 2007+ G35/G37/Q40, plus other Nissan/Infiniti models listed here: https://fortin.ca/en/products/evo-rs.../vehicles.html). ***SOLD*** OEM Paddle Shifters & Shroud Kit - $220/shipped ***SOLD*** Probably one of my favorite interior additions and super easy to install as our cars are factory prewired for these. The paddles have some slight edge wear (pictured below), but this was present when I purchased them and they did not get any worse. The shroud kit (for manual tilt wheel) is intact with no broken pieces. Hardware to mount the paddles is included, plus hardware for the shroud in case you have any missing. The shroud bolt covers are also included, just not in place for pictures. ***SOLD*** USA Spec BT45-INFI Bluetooth Adapter - $100/shipped ***SOLD*** Uses/intercepts the satellite tuner to allow Bluetooth connection to the radio, it doesn't prevent use of the satellite radio. The Q40 had no RCA, USB, etc. inputs, so this was the best solution. Compatibility chart here: https://m.media-amazon.com/images/I/81oljUZwzFL.pdf (Infiniti section is bottom of page 2). ***SOLD*** Mishimoto Silicone Intake Tubes & aFe Drop In Dry Flow Air Filters - $175 ***SOLD*** Four T-bolt clamps included. Butt dyno said these made a slight increase in power but they definitely sounded better, plus no heat soaking like short air intakes. Cleaned and ready to go. Ultra Racing Solid Shock Tower Brace - $150/shipped The changes with this were mainly noticeable during quick turns and at lower speeds. Solid design prevents flex/movement seen with 3-piece STBs where they bolt together. This is boxed and ready to ship. https://live.staticflickr.com/65535/...24b8ed7e_c.jpg https://c2.staticflickr.com/2/1754/4...dcd1c620_c.jpg Rear Diffuser Panel by TBW Performance - $150 + shipping Made out of aluminum, it replaces the rear plastic panel and looks a lot better doing it. Fits 07-08 G35, 09-13 G37, and 2015 Q40 sedans. A few fins have edge scrape damage from a bad driveway exit angle but some touch up paint made it unnoticeable unless you're right up on them while laying on the ground. https://live.staticflickr.com/65535/...a65f1d6e_c.jpg https://live.staticflickr.com/65535/...978632aa_c.jpg ***SOLD*** OEM 2010+ G37/Q40 Non-Sport Front Lip - $250 ***SOLD*** This is brand new, never installed. Factory painted in Moonlight White (QAA). Includes instructions, hardware, and mounting template. OEM G37/Q40 Trunk Lid Spoiler - $150 + shipping This was installed & removed, so replacement of the 3M mounting tape will be required. Factory painted in Moonlight White (QAA). Includes hardware and mounting bracket for the camera and trunk release button. https://live.staticflickr.com/65535/...6b730649_c.jpg Top Speed Pro 1 Y-Pipe Back Exhaust - $350 If you're looking for something that is louder than stock but is not obnoxious or raspy and has no drone at cruise, then this is the exhaust you're looking for. All cleaned up and ready for a new home. Because of the size/weight I would prefer local pickup only, although I am willing to ship once I can find packing for it if needed. I am also willing to meet within a reasonable distance. https://live.staticflickr.com/65535/...3b91e541_c.jpg |
Exhaust
Lmk asap if this exhaust & Y will fit my G37x if it does I will buy it today
|
Originally Posted by Christo7700
(Post 4325251)
Lmk asap if this exhaust & Y will fit my G37x if it does I will buy it today
You can verify if you'd like: https://topspeedauto.com/infiniti-g3...vel-edge-tips/ Please note that finding packaging to ship it might take a little bit of time, that would be the only constraint. |
Rear spoiler has been sold. The brace, diffuser, and exhaust (haven't heard back from the above user) still remain!
|
Bump for available items & lowered prices.
|
Still have exhaust? I知 located in ga
|
Originally Posted by Angel246837
(Post 4326634)
Still have exhaust? I知 located in ga
|
Do you have pictures of the diffuser on the car?
|
Originally Posted by quefresco
(Post 4326819)
Do you have pictures of the diffuser on the car?
It's been brightened a bit to take some of the shadows away and allow you to see the diffuser. https://live.staticflickr.com/65535/...04dc4816_b.jpg In case you haven't seen the pics on TBW's website, they have a few good angles: https://cdn11.bigcommerce.com/s-p02z...1654547938.jpg https://cdn11.bigcommerce.com/s-p02z...1654547938.jpg https://cdn11.bigcommerce.com/s-p02z...1654547938.jpg |
Originally Posted by RotorNutFD3S
(Post 4326637)
I do still have it However, I owe a shipping quote to someone else, if he decides to pass on it after I get him a total I will let you know!
The three remaining parts are all now available to ship and the diffuser & shock tower brace prices include shipping costs. |
Bumping this with large price reductions, need to get these last three parts out of my garage!
|
Shock tower brace is now sold!
|
still have the exhaust?
I'm also in Atlanta. |
Yes, I still have it.
|
| All times are GMT -4. The time now is 10:58 PM. |
© 2024 MH Sub I, LLC dba Internet Brands